ASME Code Calculator

Information on how to use this page 
 
Test Piece Data
 
Parent Metal Thickness   All dimensions in mm
 
Thickess Of Weld Deposit    Blank Assumes same as Parent Metal
Note the thickness of weld deposit should be checked for each welding process involved and the sum of each deposit must not exceed the thickness of the parent metal
Diameter    Blank Assumes Plate
 
Impact Tests    Required By ASME QW 403.6 
 
Welding Position 
 
           No data to be entered below this line
Procedure Approval Range Range

Min Thickness Tmin:    Max Thickness Tmax: 

Max Thickness Of Weld Deposit t:    No Minimum
Note GMAW In Dip Transfer Mode restricts max deposit size

Position: 

Special Requirements: 

Diameters: All Diameters and product forms approved Ref QW211

Joint Type: All Joint Types Approved, a double sided weld will approve single sided.

Fillet Welds: All weld sizes and parent metal thickness approved QW451.3
Note Fillet welds must be approved by a groove weld for pressure retention


Welder Qualification Approval Range

Max Thickness Of Weld Deposit t:   No Minimum

Min Diameter:   No Maximum Diameter.
Any Part containing a weld prep is subject to Diameter Limits

Welding Positions QW461

Plate & Pipe > 610mm:

Pipe < 610mm:
 

Fillet Welds: All weld sizes and parent metal thickness approved QW451.3

Single Sided Welds: Approve double sided welds and welds with backing

Double Sided Welds: Approve welds with backing and vice versa


Page last updated 23 October 2009